B2615

DTC B2615

DIAGNOSTIC INSTRUCTIONS
- Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure.
- Strategy Based Diagnosis
- Diagnostic Procedure Instructions Initial Inspection and Diagnostic Overview

DTC DESCRIPTOR

DTC B2615 00
Passenger Compartment Dimming 2 Circuit




DIAGNOSTIC FAULT INFORMATION

CIRCUIT/SYSTEM DESCRIPTION
Voltage for the courtesy lamps is supplied from the Interior Lights Fuse in the instrument panel I/P electrical center to the body control module (BCM). When a door is opened, a signal is applied to the door module. The door module then applies a message to the LAN communication circuit to the BCM. The BCM then applies voltage to the courtesy lamps voltage supply circuit. The courtesy lamps are composed of the following components:
- Dome lamps
- Reading lamps
- Cargo Lamps

CONDITIONS FOR RUNNING THE DTC
The ignition is ON, and the BCM attempts to illuminate the courtesy lamps.

CONDITIONS FOR SETTING THE DTC
The BCM receives a ground signal on the courtesy lamp voltage supply circuit

ACTION TAKEN WHEN THE DTC SETS
The BCM cease attempt to illuminate the courtesy lamps.

CONDITIONS FOR CLEARING THE DTC
The BCM clears this code from current when the fault is removed from the system.

CIRCUIT/SYSTEM VERIFICATION
Ignition ON, cover the ambient light sensor, vary the interior lamp dimming switch from dim to full bright. The light emitting diode (LED) lamps should dim and then become full bright.

CIRCUIT/SYSTEM TESTING
1. Disconnect all the courtesy lamps voltage supply circuit lamps related components. Verify the DTC B2615 does not set
- If the DTC resets then test for a short to ground in the courtesy lamp voltage supply circuit lamps circuit. If the circuit/connections test normal replace the BCM.
2. Reconnect each component one at a time and test for the DTC B2615. If the DTC resets then replace that component.

REPAIR INSTRUCTIONS
Perform the Diagnostic Repair Verification after completing the diagnostic procedure.
- Cargo Lamp Replacement
- Dome Lamp Replacement (Without DVD)
- Reading Lamp Bulb Replacement
- Control Module References for BCM replacement, setup, and programming Verification Tests Programming and Relearning