Canister Purge Solenoid: Service and Repair

EVAPORATIVE EMISSION CANISTER PURGE SOLENOID VALVE REPLACEMENT

REMOVAL PROCEDURE
1. Turn OFF the ignition.
2. Disconnect the evaporative emission (EVAP) canister purge solenoid valve electrical connector.
3. Disconnect the EVAP canister purge solenoid valve hose/pipe.




4. Remove the EVAP canister purge solenoid valve retaining bolt (2).
5. Remove the EVAP canister purge solenoid valve (1) from the intake manifold.

INSTALLATION PROCEDURE




1. Position the EVAP canister purge solenoid valve (1) on the intake manifold.

2. NOTE: Refer to Fastener Notice.

install the EVAP canister purge solenoid valve bolt (2).

Tighten the EVAP canister purge valve retaining bolt to 10 N.m (89 lb in).

3. Connect the EVAP canister purge solenoid valve hose/pipe.
4. Connect the EVAP canister purge solenoid valve electrical connector.