Multifunction Turn Signal Switch Housing Replacement

Multifunction Turn Signal Switch Housing Replacement

Removal Procedure




1. Disconnect the negative battery cable.
2. Disable the SIR system. Refer to SIR Disabling and Enabling.
3. Remove the steering wheel.
4. Remove the SIR coil.
5. Remove the steering column trim covers.
6. Depress the lock tabs on the left and right multifunction levers. Remove the multifunction levers.




7. Disconnect the housing electrical connectors.




8. Remove the lock housing bolts.
9. Separate the ignition housing from the multifunction lever bracket. Slide the bracket from the column.

Installation Procedure




1. Pre-assemble the lock housing and multifunction lever bracket. Hand-tighten the bolts, leaving approximately 3.2 mm (0.125 in) gap at the bolt ends.

Important: Ensure that the lock tab fully engages into the column slot.

2. Slide the bracket onto the column.
3. Hand-tighten the lower bolt until snug.
4. Hand-tighten the upper bolt until snug.

Notice: Refer to Fastener Notice.

5. Tighten the lower bolt.

Tighten the bolt to 8 N.m (71 lb in)

6. Tighten the upper bolt.

Tighten the bolt to 8 N.m (71 lb in)




7. Connect the ignition housing electrical connectors.





Important: Ensure that both locking tabs are seated.

8. Install the multifunction levers.
9. Install the upper and lower shrouds..
10. Install the SIR coil.
11. Install the steering wheel.
12. Enable the SIR system. Refer to SIR Disabling and Enabling.
13. Connect the negative battery cable.