Vent Hose Replacement

Vent Hose Replacement

Removal Procedure

Important: Make note of the routing in order to aid in reassembly.

1. Raise and support the vehicle. Refer to Vehicle Lifting.
2. Remove the right rear tire and wheel assembly.




3. Release the pushpin retainers from the right rear wheelhouse liner and remove the liner.




4. Release the vent hose clips (2) from the fuel vent pipe (1).




5. Release the retaining clip (2) securing the vent hose along the top of the rear suspension crossmember.
6. Remove the vent hose (1) from the differential assembly by carefully twisting the hose off of the barbed fitting.

Installation Procedure




1. Install the vent hose (1) to the differential assembly by pushing the vent hose over the barbed fitting. Ensure the vent hose is fully seated on the fitting.
2. Secure the vent hose retaining clip (2) along the top of the rear suspension crossmember.




3. Secure the vent hose clips (2) to the fuel vent pipe (3).




4. Position the wheelhouse liner to the vehicle and install the pushpin retainers.
5. Install the wheel and tire assembly.
6. Lower the vehicle.