Rear Drive Axle
DTC C0561
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle prior to using this diagnostic procedure. Initial Inspection and Diagnostic Overview
* Review Strategy Based Diagnosis for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions provides an overview of each diagnostic category.
DTC Descriptor
DTC C0561 71
- System Disabled Information Stored invalid serial data received
Diagnostic Fault Information
Circuit/System Description
The rear differential clutch control module (CCM) receives messages from other modules over GMLAN which are needed to perform all wheel drive functions
Conditions for Running the DTC
* The ignition switch is in the ON position.
* Ignition voltage is greater than 9 volts.
Conditions for Setting the DTC
The CCM receives an invalid message from the PCM, EBCM, modules over GMLAN which causes the CCM to deactivate.
Action Taken When the DTC Sets
One or more of the following actions may occur:
* All Wheel Drive Off (AWD Disabled).
* Service All Wheel Drive (Service AWD).
Conditions for Clearing the DTC
* The condition for the DTC is no longer present.
* The DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
All-Wheel Drive Schematics
Connector End View Reference
Transfer Case Control Connector End Views
Electrical Information Reference
* Circuit Testing
* Connector Repairs
* Testing for Intermittent Conditions and Poor Connections
* Wiring Repairs
Scan Tool Reference
Scan Tool Data List for CCM or PCM
Circuit/System Verification
1. Perform Diagnostic System Check - Vehicle. Initial Inspection and Diagnostic Overview
^ Diagnose any other Vehicle DTCs before attempting diagnosis of C0561.
2. With Tech 2, view Data Display list under ECM or EBCM, and review the accelerator pedal signal or the wheel speed signals for proper operation.
^ If there is no DTCs or invalid data in the ECM or EBCM, replace the CCM.
Repair Verification
Diagnostic Repair Verification