Seat Cushion Heater Element Replacement - Front (With Passenger Presence System)

SEAT CUSHION HEATER ELEMENT REPLACEMENT - FRONT (WITH PASSENGER PRESENCE SYSTEM)

REMOVAL PROCEDURE




1. Remove the front seat from the vehicle.
2. Place the seat on a clean work bench.
3. Remove the seat cushion cover and pad.
4. Do not remove the original heater element from the seat foam, damage could occur to the inflatable restraint passenger presence system (PPS) or foam pad. If this is the second repair, separate and remove the service heater element from the original element. No more than two heater elements can be stacked on top of the PPS at one time.
5. Cut the wiring harness off the old heater element flush to the element.

INSTALLATION PROCEDURE




1. Peel off the self-stick tape from the back of the heater element.
2. Position the heater element over the seat foam pad and align the tabs and holes of the heater element to the seat foam. Press firmly to engage the adhesive.
3. Route the heating element wiring harness under the seat pad and connect the harness to the heater module. Secure the wire with tie straps.
4. Install the seat cushion cover and pad.
5. Install the front seat to the vehicle.

6. IMPORTANT: Perform the passenger presence system preload test procedure when performing any repairs to the passenger seat.

Preload test the inflatable restraint passenger presence system for the front passenger seat. Refer to Control Module References. Programming and Relearning