Instrument Panel Electrical Center or Junction Block Replacement
Instrument Panel Electrical Center or Junction Block Replacement
Removal Procedure
Important: Record all preset radio stations.
1. Turn the ignition OFF.
2. Remove the screws from the battery cooling box. Remove the battery cover.
3. Disconnect the negative battery cable.
4. Disconnect the positive battery cable.
5. Remove the console.
6. Remove the nut holding the following fuse block connectors to the back of the I/P fuse block (4):
* The body connector (1)
* The I/P connector (2)
* The I/P connector (3)
7. Remove the bolt holding the fuse block into place.
8. Remove the ground wire (1).
9. Remove the fuse block.
Installation Procedure
Notice: Refer to Fastener Notice.
1. Install the fuse block and attach the ground wire (1) and attach the bolt.
Tighten the bolt to 10 N.m (89 lb in).
2. Connect the harness connectors to the back of the I/P fuse block (4).
Tighten the connectors to 4 N.m (35 lb in).
3. Install the console.
4. Connect the positive battery cable.
Tighten the bolt to 17 N.m (13 lb ft).
5. Connect the negative battery cable.
Tighten the bolt to 17 N.m (13 lb ft).
6. Install the battery cooling box cover and install the screws.
Tighten the screws to 2 N.m (18 lb in).
7. Set the radio stations to the preset selections.