1-2 Reverse Clutch Disassemble

1-2 Reverse Clutch Disassemble


Tools Required
* J 23327 Clutch Spring Compressor
* J 28585 Snap Ring Remover
* J 23456 Booster and Clutch Pack Compressor
* J 45184 Differential Bearing Race Installer






1. Remove the 1-2 reverse clutch backing plate retaining ring (622) using J 28585 .
2. Remove the following components:

* The 1-2 reverse clutch backing plate (621)
* The 6 1-2 reverse clutch fiber plates (620)
* The 6 1-2 reverse clutch steel plates (619)
* The 1-2 reverse clutch apply plate (618)






Important: Do not bend the 1-2 reverse clutch piston return spring assembly (601).


3. Place J 45184 (1) on the center of J 23456 (2).
4. Place the transmission case cover (19) with the 1-2 reverse clutch piston assembly onto J 45184 (1).
5. Using J 23327-1 (3), which is the bridge part of J 23327 , compress the 1-2 reverse clutch piston return spring assembly (601).
6. Remove the 1-2 reverse clutch piston return spring retaining ring (600) using snap ring pliers.
7. Remove the pressure from J 23456 (2), remove J 23327-1 (3) and the 1-2 reverse clutch piston return spring assembly (601).
8. Remove all tools.





Caution: Wear safety glasses when using compressed air in order to prevent eye injury.

9. While pulling upward on the piston by hand, apply compressed air into the 1-2 reverse clutch fluid passage and remove the 1-2 reverse clutch piston (603).
10. Remove the 1-2 reverse clutch piston inner seal (602).
11. Remove the 1-2 reverse clutch piston outer seal (604).