C0131
DTC C0131
Diagnostic Instructions
* Perform the Diagnostic System Check - Vehicle (Initial Inspection and Diagnostic Overview) prior to using this diagnostic procedure.
* Review Strategy Based Diagnosis (Initial Inspection and Diagnostic Overview) for an overview of the diagnostic approach.
* Diagnostic Procedure Instructions (Initial Inspection and Diagnostic Overview) provides an overview of each diagnostic category.
DTC Descriptors
DTC C0131 00
- ABS Pressure Circuit
DTC C0131 5A
- ABS Pressure Circuit Plausibility Failure
Circuit/System Description
The electronic brake control module (EBCM) monitors the inputs of the 2 internal brake pressure sensors and compares the reading so they correlate.
Conditions for Running the DTC
Ignition ON.
Conditions for Setting the DTC
C0131 00
The EBCM detects an internal pressure sensor are fault.
C0131 5A
The EBCM detects the 2 internal brake pressure sensor readings do not correlate.
Action Taken When the DTC Sets
* The EBCM disables the ABS/traction control system (TCS)/vehicle stability enhancement system (VSES) for the duration of the ignition cycle.
* A DIC message and/or a warning indicator may be displayed.
Conditions for Clearing the DTC
* The condition for setting the DTC is no longer present.
* The EBCM clears the history DTC when a current DTC is not detected in 100 consecutive drive cycles.
Reference Information
Schematic Reference
Antilock Brake System Schematics ([1][2]Antilock Brakes / Traction Control Systems)
Connector End View Reference
Component Connector End Views (Connector Views)
Description and Operation Reference
ABS Description and Operation (Description and Operation)
Electrical Information Reference
* Circuit Testing (Component Tests and General Diagnostics)
* Testing for Intermittent Conditions and Poor Connections (Component Tests and General Diagnostics)
* Wiring Repairs (Component Tests and General Diagnostics)
* Connector Repairs (Component Tests and General Diagnostics)
Scan Tool Reference
Control Module References (Programming and Relearning) for scan tool information
Circuit/System Verification
C0131 00
1. Replace the brake pressure modulator valve (BPMV).
2. With a scan tool, perform the steering angle sensor calibration procedure.
3. Verify DTC does not reset. If DTC reset, replace the EBCM.
C0131 5A
Verify DTC C0131 5A is not set.
If DTC is set, with a scan tool perform the special function, steering angle sensor calibration.
Repair Instructions
Perform the Diagnostic Repair Verification (Verification Tests) after completing the diagnostic procedure.
* Brake Pressure Modulator Valve Replacement (Service and Repair)
* Control Module References (Programming and Relearning) for EBCM replacement, setup, and programming