Crankshaft Position Sensor: Service and Repair

Crankshaft Position Sensor Replacement

Removal Procedure




1. Raise the vehicle. Refer to Lifting and Jacking the Vehicle (Service and Repair).
2. Disconnect the crankshaft position (CKP) sensor electrical connector.
3. Remove the CKP sensor nut (2).
4. Remove the CKP sensor (1) from the engine.
5. Inspect for wear, cracks, or leakage if the CKP sensor is being reused.

Installation Procedure

1. Lubricate the O-ring with clean engine oil. Replace the O-rings if damaged.




2. Install the CKP sensor (1) to the block.

Caution: Refer to Fastener Caution (Fastener Caution).

3. Install the CKP sensor nut (2).

Tighten the nut to 11 Nm (97 lb in).

4. Connect the CKP sensor electrical connector.
5. Lower the vehicle.
6. Perform the Crankshaft Position System Variation Learn. Refer to Crankshaft Position System Variation Learn (Service and Repair).