Engine Support Fixture

Engine Support Fixture

Special Tools
* J 28467-B Universal Engine Support Fixture
* J 28467-7A Bolt Hook
* J-28467-13 Engine Support Fixture Adapters
* J 28467-34 Lift Hook Wing Nut and Washer
* J 36462-A Engine Support Adapter Leg Set
* J 42451-1 Engine Support Adapter

Installation Procedure




1. Remove the fuel injector sight shield. Refer to Fuel Injector Sight Shield Replacement (Service and Repair).
2. Pull each end of the hood rear seal away from the cowl panel flange near both strut towers.
3. Install three J-28467-13 (1) and two J 28467-5 strut tower adapters (2) to the top of the left and right strut tower.
4. Install a 127 cm (50 in) engine support fixture cross bar J 28467-B (3) transversely across the vehicle between both J 28467-5 strut tower adapters (2).
5. Insert safety pins J-28467-10 (4) through the J 28467-5 strut tower adapters (2) and the cross bar (3) to prevent movement.




6. Install the engine support bracket J 42451-1 to the engine.





Caution: Refer to Fastener Caution (Fastener Caution).

7. Remove the alternator bolt (1), then install the alternator bolt with the engine support bracket J 42451-1 to the engine and tighten to 50 Nm (37 lb ft).




8. Position two 58 cm (23 in) engine support fixture cross bars (1) longitudinally with two J 36462-A leg assembly (2).
9. Install two J 28467-1A clamp (3) to secure the longitudinal mounted cross bar to the transverse mounted cross bar.




10. Assemble the lift hook wing nut J 28467-34 and the lift hook bracket J-28467-6A to the lift hook J 28467-7A .




11. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).




12. Position the J 28467-7A lift hook to the rear engine lift bracket J 42451-1 (2).




13. Assemble the lift hook wing nut J 28467-34 and the lift hook bracket J-28467-6A to the lift hook J 28467-7A .




14. Install the lift hook and bracket assembly (1) to the longitudinal mounted cross bar (2).




15. Position the J 28467-7A bolt hook (1) to the front engine lift bracket J 42451-1 (2).




16. Evenly tighten both wing nuts J 28467-34 (1) until the engine weight is supported by the engine support fixture and no longer carried by the engine mounts.