Engine - Removal Procedure Revision
Number 84-6 (Gasoline)-4 Date 10/83Subject: ENGINE REMOVAL PROCEDURE REVISION (2.0L) - 1983-1984 2000 MODELS
The following procedure should be used whenever it becomes necessary to remove an engine in the above models:
1. Disconnect battery.
2. Drain cooling system.
3. Remove air cleaner.
4.. Disconnect accelerator and T.V. cables.
5. Disconnect ECM harness at engine.
6. Disconnect necessary vacuum hoses.
7. Disconnect radiator hoses at engine.
8. Disconnect heater hoses at engine.
9. Remove exhaust heat shield.
10. If equipped with A/C, remove adjustment bolt at motor mount.
11. Disconnect engine wiring harness at bulkhead.
12. Remove windshield washer bottle.
13. Remove alternator belt.
14. Remove power steering belt.
15. Disconnect fuel hoses.
16. Raise vehicle.
17. If equipped with A/C, remove A/C brace.
18. Remove inner fender splash shield.
19. If equipped with A/C, remove A/C compressor.
20. Remove flywheel splash shield.
21. Disconnect starter wires.
22. Disconnect front starter brace.
23. Remove starter.
24. Remove torque converter bolts.
25. Remove crankshaft pulley.
26. Remove crankshaft hub using tool J-24420.
27. Remove oil filter.
28. Disconnect engine to transmission bracket.
29. Disconnect right rear motor mount.
30. Disconnect exhaust at manifold.
31. Disconnect exhaust at center hanger and loosen muffler hanger.
32. Disconnect T.V. and shift cable bracket.
33. Remove lower two bellhousing bolts.
34. Lower vehicle.
35. Remove right front motor mount nuts.
36. Remove alternator and adjusting brace.
37. Disconnect master cylinder and push aside.
38. Install lifting device.
39. Remove right front motor mount bracket.
40. Remove upper bellhousing bolts.
41. Remove power steering pump while lifting engine.
42. Remove engine.