Clutch: Service and Repair

1. Remove transmission as described under ``Transmission, Replace.''
2. On 1982---83 models, disconnect clutch fork pushrod and spring.
3. On 1984---88 models, disconnect pushrod from clutch master cylinder, then remove slave cylinder heat shield and the slave cylinder from flywheel housing.
4. On all models, remove flywheel housing from engine.
5. Slide clutch fork from ball stud and remove fork from dust boot. Look for an ``X'' mark on flywheel and clutch cover. If ``X'' mark is not evident, make punch marks on flywheel and clutch cover for indexing purposes during installation.
6. Loosen clutch-to-flywheel attaching bolts evenly one turn at a time until spring pressure is released, then remove bolts and clutch assembly.
7. Reverse procedure to install, using suitable pilot tool to center clutch disc. Tighten clutch cover bolts evenly and gradually to avoid distorting cover.