Throttle Body Fuel Injection System

Fig. 002 - Wiring Diagram for Chart C-1A Park/Neutral Switch. VIN 0, VIN 2, VIN R, VIN U:

CHART C-1A,

PARK/NEUTRAL SWITCH

1.8L "J" SERIES

2.5L "A, X, & N" SERIES

The Park/Neutral Switch contacts are a part of the Neutral Start switch and are closed to ground in park or neutral, and open in drive ranges.
The ECM supplies ignition voltage through a current limiting resistor to CKT 434 and senses a closed switch when the voltage on CKT 434 drops to less than one volt.
The ECM uses the P/N signal as one of the inputs to control;
- Idle Air Control (IAC)
- VSS Diagnostics

Fig. 001 Chart C-1A Park/Neutral Switch:

1. Checks for a closed switch to GND in park position. Use of an ohmmeter instead of a test light to 12 volts, the resistance will be low indicating continuity to ground.
2. Checks for an open switch in drive range. Use of an ohmmeter instead of a test light to 12 volts, the resistance will be high or infinity, indicating an open switch.
3. Checks to this point indicate the P/N switch and wiring are OK, however, the ECM signal voltage on CKT. 434 may be missing. To check, reconnect ECM. Either back probe ECM connector circuit 434 with selector in drive or disconnect P/N switch and probe harness connector CKT 434 with a voltmeter to ground.