Power Steering Pressure Switch: Testing and Inspection

Fig. 048 - Wiring Diagram for Chart C-1E Power Steering Pressure Signal. VIN P:

CHART C-1E

POWER STEERING PRESSURE SWITCH

2.0L "J" SERIES

FUEL INJECTION (TBI)

The power steering pressure switch is normally open to ground, and circuit 901 will be near battery voltage.
Turning the steering wheel increases power steering oil pressure and its load on an idling engine. The pressure switch will close before the load can cause an idle problem.
Closing the switch causes circuit 901 to read less than 1 volt. And the ECM will increase the idle air rate.
a. A pressure switch that will not close, or an open CKT 901 or 450, may cause the engine to stop when power steering loads are high.
b. A switch that will not open, or a CKT 901, shorted to ground, may effect idle quality.

Fig. 047 Chart C-1E Power Steering Signal:

1. Checks for ECM signal voltage on CKT 901, and confirms that ground CKT 450 is OK.
2. Maximum resistance, or infinity, indicates an open switch.
3. Less than 1 ohm indicates that the switch is closed when the power steering pressure is high. Switch is OK.