Distributor Service

Fig. 14 Exploded view of H.E.I. distributor (Typical).:

DISASSEMBLY
1. Remove distributor, Fig. 14.
2. Remove rotor.
3. Remove advance springs and weights (if equipped).
4. Remove module retaining screws and move module to a position where connector may be removed.
5. Remove wires from module terminals.
6. Support distributor gear so that distributor shaft will not be damaged, then remove roll pin by driving it out with a punch.
7. Remove gear, shim and washer with tang from shaft. Remove any burrs that may have been caused by removal of roll pin.

Note: Some distributors do not use a shim or tanged washer.

8. Remove distributor shaft and magnet assembly.
9. Remove pole piece retaining screws, pole piece, magnet and pick-up coil.
10. Remove lock ring from top of housing, pick-up coil retainer and felt washer.
11. Remove vacuum advance unit (if equipped).
12. Remove capacitor and wiring harness from distributor housing.

ASSEMBLY
1. Install vacuum advance unit (if used) and secure with two screws, Figs. 14.
2. Place felt washer over lubricant reservoir at top of housing.
3. Position pickup coil retainer onto housing with vacuum advance arm over actuating pin of vacuum advance mechanism and secure with lock ring.
4. Install pickup coil magnet and pole piece. Loosely install the three retaining screws.
5. Install distributor shaft and rotate to check for even clearance all around between pole piece and shaft projections.
6. Move pole piece to provide even clearance and secure with three retaining screws.
7. Install drive with teeth up onto shaft.

Note: Drive gear has a dimple on one side next to drive pin hole. Align drive gear so that dimple is on same side of shaft as the rotor pointer. Temporarily install rotor to ensure correct alignment.

8. Install tanged washer, shim and drive gear, then retain with a new roll pin.
9. Install capacitor and loosely install retaining screw.
10. Install connector on module with tab on top, then liberally apply silicone grease to bottom of module and install screws.

Note: Failure to apply silicone grease to module will cause excessive heat build-up of module and premature failure.

11. Position wiring harness with grommet in housing notch, then connect pink wire to capacitor stud and black wire to capacitor retaining screw. Tighten screw.
12. Reconnect wires to module, then install centrifugal advance weights and springs.