ECM - Metri-Pack Series 150 Terminal Removal

Number 86-8-14A Date 5/85

Subject: METRI-PACK SERIES 150 TERMINAL REMOVAL

ALL MODELS

METRI - PACK SERIES 150 TERMINAL:

Some connectors used to connect various sensors to the ECM harness are shown in Figure A. (The example shown is a three terminal type.) These connectors may be used at the cam, crankshaft, mat and coolant sensors along with ignition modules.

Terminals in these connectors are the pull-to-seat type. The wire is inserted through the connector body (4) and the seal (5). The terminal (1) is crimped to the stripped wire, then pulled back into the connector body until it is locked in place.

To remove the terminals (1), first slide the seal (5) back on the wires, then insert tool (3) BT-8446 or J 35689 as shown in Figure B. To release the terminal, push the wire and terminal through the connector. If reusing the terminal, reshape the locking tang (2).
1. METRI - PACK SERIES 150 FEMALE TERMINAL
2. LOCKING TANG
3. TOOL J 35689 OR BT-8446
4. CONNECTOR BODY
5. SEAL