Front Door Scalp Molding

PONTIAC FRONT DOOR:

FRONT DOOR SCALP MOLDING WITH AUXILIARY WINDNOISE CLOSEOUT SEAL

SERVICE INSTALLATION INSTRUCTIONS

1. Apply soap solution to cover complete perimeter of outer edge of stationary door frame. Completely cover black scalp molding clip at lower front edge of door frame.

2. Slide front door window frame scalp molding assembly three quarters of the way down over the black scalp molding clip at the lower front of the door.

3 and 4. Position front door window frame scalp molding assembly to
front door. Starting at the upper rear corner, engage over outer edges of the top leg and upper rear vertical leg of the door frame simultaneously. (Figure 2) working in the order depicted in Figure
3. Once corner on frame, push scalp molding as far forward as possible on horizontal leg of header.
5 - 11. Engage molding over the outer edge of the stationary door
frame and snap molding onto retainer clips on the inner edge of stationary door frame (Figure 2) working in the order depicted in Figure 3.

IMPORTANT: Cross section of correctly installed molding (Figure 4). Kent-Moore Installation Tool # J-38714 will be available May 4.