Front Seat - Hard/Too Firm
Number 87-10-10 Date 2/87Subject: FRONT SEAT DISCOMFORT
EARLY 1987 BONNEVILLE MODELS (INTO JANUARY PRODUCTION)
FRONT SEAT ASSEMBLY:
If a comment on firm or hard front seat cushion is received, the following procedure can be used to soften either driver or passenger side:
^ See Illustrations.
^ Determine if correction has already been done, reach under seat to check if center element (spring) is present. If so, continue to next step.
^ Remove front seat.
^ Detrim seat bottom, front, and sides. It is not necessary to remove adjusters.
^ Remove two (2) hog rings from rear of seat trim, to gain access to rear of element.
^ Remove front and rear clips from center element.
^ Open attaching tabs on seat frame, at ends of element.
^ Remove element only from side which condition exists.
^ Retrim seat..
^ Reinstall seat.
WARRANTY INFORMATION
Labor Operation Numbers: Labor Time:
T5135 Split Seat .7 for each side
T5136 Bench Seat .7 for one (1) side
T5137 Bench Seat .8 for both sides
Trouble Code: 92