Speedometer Cable Replace

FIGURE 1:

Remove:

1. Locate vehicle speed sensor at transaxle.

2. Cut wire-tie (chicken band) that holds multiple plug connector to speedometer cable.

3. Unscrew speedometer cable from vehicle speed sensor.

4. Remove speedometer cable rubber mount from cowl.

5. Cut wire-tie (chicken band) that holds wire loom and speedometer cable to clutch and brake mounting bracket.

6. At rear of speedometer, press cable retainer connection downwards and simultaneously pull off cable. Remove cable.

FIGURE 2:

Install:

1. From engine compartment, feed cable through cowl and press grommet in place in cowl.

2. Pilot cable into vehicle speed sensor and install retaining cap screw.

3. Connect multiple plug connector and mounting strap.

4. Feed cable up to rear of speedometer and snap cable in place.

5. Install mounting strap.