Unit Repair

Figure 3 - Control Assembly Removal:

CONTROL BUTTON ASSEMBLY

Figure 3

vRemove or Disconnect

1. Pry out control button assembly with thin bladed screwdriver along top edge of assembly.
2. Disconnect steering wheel control connector.

vInstall or Connect

1. Connect steering wheel control connector.
2. Push control button assembly into place.

CONTROL BUTTON ASSEMBLY BULBS

These bulbs are not replaceable at the dealership. For bulb replacement, send the control button assembly to a Delco repair shop.

HORN OPERATION

Horn operation is not affected by the steering wheel control system or removal of the control button assembly.

Figure 4 - Removing Steering Wheel:

STEERING WHEEL

Figure 4 Tools required:
J1859-03 String Wheel Puller

Figure 5 - Control Button Removal:

CONTROL BUTTONS

Figure 5

Remove or Disconnect

1. Control button assembly (see preceding steps).
2. Rocker Button (with arrows)
^ Pull up at edge with arrow until button comes off pivot post.
3. Push Button
^ Pull up at edge carefully
^ When button comes out of actuators they may loosen. Check proper placement of actuators.

vInstall or Connect

1. Rocker Button(with arrows)
^ Properly position rocker button on pivot posts and press down until seated.
2. Push Button
^ Push button evenly on both sides until both sides of button are seated in actuator.
3. Make sure rubber lightshield is in place.
4. Control button assembly (see preceding steps).