Isolation of Sunshade, Air Deflector, Shield.

plate with a hammer to seat it over the raised staking area on the track. Ensure that the plate is flush to the track surface prior to riveting.

8. Secure the two pivot plates using the four black rivets supplied in the kit.

9. Reinstall headliner and trim lace.

For warranty purposes use Labor Operation T6429 at .6 hour.

Isolation of Sunshade, Air Deflector, Shield. To isolate components and eliminate rattles in the rest of the sunroof assembly, complete all of the following steps on 1988 and 1989 vehicles. Add loop material (soft loop half of hook-and-loop fastener system, such as Velcro or Scotchmate Hook and Loop Fastener, 3M P/N 06480) in the following locations as required:

1. Remove sunshade. Open glass panel part way.

Figure 3 - Glass Panel Loop Material Locations:

2. Add loop material (40 mm long) at the front of the glass panel on the underside. Refer to Figure 3 for locations. This prevents air deflector rattles against the bottom of the glass panel.
3. Add a small pad (10 mm) of loop material at the top front corners of the track. Locate pad so deflector rests on it when closed.

Figure 4 - Sunshade Loop Material Locations:

4. Add loop material, approximately 70 mm long, on the top (back side) of the sunshade in the area of the reinforcement. Refer to Figure 4 for locations.
5. Add one piece of loop material at the rear of the sunshade, approximately 50 mm long, wrapped around the edge at the center.

6. Reinstall sunshade.

For warranty purposes use Labor Operation T6345 at .6 hour (1988 and 1989 vehicles only).