Cylinder Head Replacement - Right Side

Fig. 5 Cylinder Head Replace & Bolt Tightening Sequence:

1. Remove intake manifold as described under INTAKE MANIFOLD.
2. Remove spark plugs.
3. Remove exhaust manifold as described under EXHAUST MANIFOLD.
4. Raise and support vehicle, then drain coolant from engine block.
5. On 1991-92 models, drain crankcase and remove oil filter.
6. On all models, lower vehicle.
7. Loosen rocker arms until push rods can be removed.
8. Remove serpentine drive belt, then remove belt tensioner.
9. Remove alternator and brackets.
10. On 1991-92 models, disconnect engine ground cable from rear of cylinder head.
11. Remove cylinder head attaching bolts, then remove cylinder head.
12. Reverse procedure to install. Prior to installation, coat cylinder head bolts with sealer 1052080 or equivalent. Torque cylinder bolts in sequence shown in Fig. 5.