440-T4 Automatic Transaxle

1. Disconnect battery ground cable.
2. Remove air cleaner assembly, then disconnect T.V. cable at both ends.
3. Disconnect shift linkage from transaxle.
4. Install engine support fixture, then disconnect converter clutch electrical connector.
5. Remove 3 transaxle-to-engine attaching bolts.
6. Disconnect vacuum line from modulator.
7. Raise and support vehicle.
8. Remove left front wheel, then the lower ball joint pinch nut.
9. Remove brake line bracket from strut, then disconnect drive axles from transaxle.
10. Remove cradle-to-stabilizer attaching bolts.
11. Remove stabilizer-to-control arm attaching bolts, then the left front cradle assembly.
12. Disconnect speedometer cable from transaxle, then remove extension housing-to-engine block support bracket.
13. Disconnect cooler lines from transaxle, then remove right and left insulator attaching bolts.
14. Remove flywheel splash shield.
15. Mark relationship of flywheel to converter, then remove flywheel attaching bolts.
16. Remove all remaining transaxle-to-engine attaching bolts except one.
17. Support transaxle with a suitable jack, then remove remaining bolt and carefully lower transaxle from vehicle.
18. Reverse procedure to install.