To Add Customer's Code-Set

C. TO ADD CUSTOMER'S CODE-Set User Code (activate) From Unlocked Mode, Deterrent Deactivated.

1. With the radio off, hold in presets 1 and 4 for about 4 seconds until the display changes to "- - - " "- - -"

IMPORTANT: If "SEC" is displayed, the theft "SEC" deterrent is already activated. This means the old code must be removed first before entering a new code.

2. Press the set button. "000"

3. Set the first digit (0-9) of your code with the seek button. "100"

4. Set the next two digits (0-99) of your code with the scan button. "123"

5. Press the AM-FM button to enter the first three digits. "000"

6. Again, use seek to set the 4th digit (0-9) of your code. "400"

7. Set the last two digits (0-99) of your code with the scan button. "456"

8. Press the AM-FM button to enter the last
3 digits of your code. "REP"

9. When "REP" then "000" are displayed, repeat "000" steps 3 through 8 of this procedure to enter your code again before the display changes back to clock. This confirms your customer code, activates the theft deterrent, and after step 8 displays the "SEC" to show the "SEC"
theft deterrent has been activated. Any time
battery power is cycled and ignition is applied
the display will show "LOC" and need to be "LOC"
unlocked by either your customer code or the factory backup code.