A/C Compressor - Overhaul Update
89Pontiac24Bulletin Number: 90-1-3
Reference Number: 931401
Publish Date: 11/89
Subject: SERVICE MANUAL UPDATE SECTION 1D3, AIR CONDITIONING COMPRESSOR OVERHAUL (REPLACEMENT PAGE)
Models
Affected: 1990 SUNBIRD
Page 1D3-6 attached should be inserted in the 1990 Pontiac Sunbird Service Manual in place of 1D2-6 which was placed in this Section in error.
Page 1D2-6 is correct for 1D2-6, but 1D2-6 was mistakenly entered in 1D3. Please correct your Service Manual.
Figure 10 - Installing Pulley Rotor/Bearing Puller Guide:
Figure 11 - Removing Pulley Rotor and Bearing Assembly:
Figure 12 - Pulley Rotor Bearing Removal:
1D3-6 V-5 AIR CONDITIONING COMPRESSOR OVERHAUL
3. Install pulley rotor and bearing puller guide J-33023 to the front head and install J-33020 pulley rotor and bearing puller down into the inner circle of slots in the rotor. Turn the J-33020 puller clockwise in the slots to engage the puller tangs with the segments between the slots in the rotor.
4. Hold the J-33020 puller in place and tighten the puller screw against the puller guide to remove the pulley rotor and bearing assembly.
5. To prevent damage to the pulley rotor during bearing removal the rotor hub must be properly supported. Remove the forcing screw from J-33020 puller and, with the puller tangs still engaged in the rotor slots, invert the assembly onto a solid flat surface or blocks.
6. Drive the bearing out of the rotor hub with rotor bearing remover J-9398-A and J-29886 universal handle. It is not necessary to remove the staking in front of the bearing to remove the bearing, however, it will be necessary to file away the old stake metal for proper clearance for the new bearing to be installed into the rotor bore or the bearing may be damaged.
Install or Connect
1. Place the pulley rotor on the J-35372 support block to fully support the rotor hub during bearing installation.