Component Diagnostic Charts (C-Charts) - Throttle Body Fuel Injection

Chart C-8A:

Wiring Diagram For TCC:

CIRCUIT DESCRIPTION:

The purpose of the automatic transmission/transaxle Torque Converter Clutch (TCC) feature is to eliminate the power loss of the torque converter when the vehicle is in a cruise mode. This allows the convenience of the automatic transmission/transaxle and the fuel economy of a manual transmission. Voltage is supplied to the TCC solenoid through the brake switch and transaxle third gear apply switch. The ECM will engage the TCC by grounding circuit 422 to energize the solenoid.

The TCC will engage when the following conditions exist:
1. Vehicle speed above 30 mph (48 km/h).
2. Engine at normal operating temperature above 70°C (156°F).
3. Throttle position sensor output is not changing, indicating a steady road speed.
4. Transaxle third gear switch is closed.
5. Brake switch closed.



TEST DESCRIPTION: The numbers below refer to circled numbers on the diagnostic chart.

1. Light "OFF" confirms transaxle third gear apply switch is open.
2. At 30 mph (48 km/h), the transaxle third gear switch should close. A test light will illuminate and confirm battery supply, and close the brake switch.
3. Grounding the diagnostic terminal with the engine "OFF" should energize the TCC solenoid. This checks the capability of the ECM to control the solenoid.


DIAGNOSTIC AIDS:

An engine coolant thermostat which is stuck open or opens at a low temperature may result in an inoperative TCC.