Parts Information and Service Procedures

PARTS INFORMATION





Parts required to complete this campaign are to be obtained from General Motors Service Parts Operation (GMSPO). To ensure that these parts are obtained as soon as possible, they should be ordered from GMSPO on a C.I.O. order with no special instruction code, but on advise code (2).

SERVICE PROCEDURE

1. Move seat to full rearward position. On a 6-way power seat, also move the seat to the full up position.

2. Remove the front track covers and adjuster to floor pan bolts. Move seat to the full forward position.





3. Remove the rear track covers and adjuster to floor pan bolts. Tilt the seat completely back so that the entire area under the seat cushion is visible (see Illustration).

4. Cut and remove the strap attaching the wiring harness to the spring wire near the middle of the seat.

5. Inspect the wiring harness. Make repairs as necessary with electrical tape.

6. Install the wiring harness into clip P/N 10112015. Reroute the wiring harness through the detent and insert the clip into the forward most hole in the seat cushion frame (see Illustration).

Notice:
The harness must not be pinched between the cushion and spring, or contact sharp edges.

7. Tilt the seat back to its original position and align. Install adjuster to floor pan bolts and torque to 24 N-m (18 lb.ft.). Install the track covers.

8. Repeat for opposite front seat if applicable.

9. Install a Campaign Identification label.