Keyless Entry: Service and Repair

^ Do the following when replacing the Keyless Entry Module or either Transmitter.

1. Turn Ignition Switch to OFF.

2. Jumper Program Connector terminal A (RED) (LE & SE) or (TAN) (SSE) to terminal B (BLK), Door locks will lock and unlock in approximately 2 seconds.

3. Press UNLOCK Button on one Transmitter. Door locks will lock and unlock in approximately 2 seconds. The first Transmitter is now programmed.

4. Repeat step 3 using other Transmitter. If only one Transmitter is being used , go to step 5.

5. Disconnect jumper from Program Connector.