Ignition Lock Cylinder

Fig. 5 Ignition Lock Installation. Models Less Supplemental Inflatable Restraint System:

MODELS LESS SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM

1. Remove steering wheel as described under STEERING WHEEL.
2. Remove turn signal switch as described under TURN SIGNAL, then remove buzzer switch.
3. Place ignition switch in Run position, then remove lock cylinder retaining screw and lock cylinder.
4. Install by rotating lock cylinder to stop while holding housing, Fig. 5. Align cylinder key with keyway in housing, then push lock cylinder assembly into housing until fully seated.
5. Install lock cylinder retaining screw.
6. Install buzzer switch, turn signal switch and steering wheel.

Fig. 6 Ignition Lock Installation. Models With Supplemental Inflatable Restraint System:

MODELS WITH SUPPLEMENTAL INFLATABLE RESTRAINT SYSTEM

1. To avoid personal injury when servicing models equipped with Supplemental Inflatable Restraint (Airbag) System, temporarily disarm system. Refer to Air Bags and Seat Belts/Air Bags (Supplemental Restraint Systems)/Service and Repair.
2. Remove steering wheel as described under STEERING WHEEL.
3. Remove turn signal switch as described under TURN SIGNAL.
4. Place ignition switch in Lock position.
5. Remove lock cylinder retaining screw, Fig. 6.
6. Disconnect terminal electrical connector at bulkhead connection to provide slack.
7. Remove wiring connector from steering column.
8. Attach a suitable length of mechanic wire to ignition lock electrical connector for use during installation. Detach wire retaining clip, then carefully pull ignition lock wiring through housing shroud, steering column and lock housing cover.
9. Remove lock cylinder.
10. Reverse procedure to install. Ensure lock cylinder wiring is properly routed through steering column. Torque lock cylinder retaining screw to 22 lb in
11. After completing service procedure, activate Supplemental Inflatable Restraint (Airbag) System. Refer to MAINTENANCE PROCEDURES/AIRBAG SYSTEM DISARMING.