Seat Belt Quarter Trim Cap Issues

Application:
1991-1992

CONDITION:

Seat belt twisting at B-pillar trim cap in vehicles prior to 1992 VIN 203520.

CORRECTION:

Replace both trim caps with P/N 12517754-5 right and left and bezels with P/N 12508710-11 right and left.

1. Completely lower convertible top.





2. Refer to Figure 6. Remove attaching screws. Remove old quarter trim caps and shoulder belt bezels.

NOTE:
Some vehicles may already have a new bezel and only need a new cap. If a new bezel is installed, make sure it is installed on the proper side.

3. Using new bezel as a template, mark locations and drill 3.0 mm (1/8") attaching holes in vehicle and new trim cap.



4. Install new cap P/N 12517754-5 and new bezel P/N 12508710-11. Match bezel with proper side to avoid improper fit and binding.

5. Check belts for smooth operation. Raise and latch top.

LABOR OPERATION:
C4018
TIME ALLOWANCE:
1.0 HR. for Both

SEAT BELT QUARTER TRIM CAP ISSUES (II)

Application:
1991

CONDITION:

Convertible topstack folding mechanism rubs against B-pillar trim cap.

CORRECTION:





Add 25 mm (1") square piece of felt to both trim caps at rear of outboard surface. See Figure 7. The felt insulator material has adhesive backing and may be obtained from most local fabric stores. As an option use loop portion of 3M # 06480 Scotchmate Hook and Loop Fastening System.

1. Lower top.

2. Install 25 mm (1") square piece of adhesive backed felt to quarter trim cap at rear of outboard surface. See Figure 7. Patch will overlap B-pillar trim cap.

3. Raise and latch top.

LABOR OPERATION:
T1872
TIME ALLOWANCE:
0.2 HR. for Both