Hub & Bearing

FRONT HUB/BEARING

Fig. 9 Removing Hub From Steering Knuckle:

Fig. 10 Remove Bearing Inner Race From Hub:

Fig. 11 Removing Bearing From Steering Knuckle Bore:

1. Remove steering knuckle as under STEERING KNUCKLE & STRUT ASSEMBLY.
2. Remove hub from steering knuckle and wheel bearing using tools J-37105-1 or J-37105-3 or equivalent, Fig. 9.
3. Using tool Nos. J-22888-35 or J-22888-36 or equivalent, remove bearing race from hub, Fig. 10.
4. Remove snap rings retaining bearing to steering knuckle, then remove bearing using tool J-37105-1 or J-37105-3 or equivalent, Fig. 11.
5. Position snap ring into steering knuckle bore, then install bearing using tool No. J-37105-1 or J-37105-3 or equivalent.
6. Using tool No. J-37105-1 or J-37105-3 or equivalent, pull hub onto bearing assembly and steering knuckle, then install snap ring.