Service Procedure

1. Open driver's door and verify that the Vehicle Identification Number (VIN) of the new certification label is the same as the existing label (see illustration for location).

If the VIN of the new certification label is different than the existing label, contact your zone office to arrange to receive the correct label.


If the VIN of the new certification label is the same as the existing label, follow the remaining steps of this procedure and install the new label.

2. Clean the surface of the old label with soapy water and wipe dry. Remove protective backing from new label, and carefully apply to vehicle over old label.

DO NOT ATTEMPT TO REMOVE OR LOOSEN THE NEW LABEL ONCE IT HAS BEEN APPLIED, AS THIS WILL DAMAGE THE LABEL AND MAKE IT ILLEGIBLE.

3. Install Campaign Identification Label.