Test C: Starter Enable Relay Test

Test C: Starter Enable Relay Test:

C2. Connect a fused jumper between terminals 1 (YEL) and 4 (YEL) of the Starter Enable Relay connector. Turn Ignition Switch to START.
^ If engine cranks, proceed to C3.
^ If engine does not crank, check YEL (575) wire for an open. When wire is OK, go to diagnosis of Starter and Charging circuits.
C3. Reconnect the Starter Enable Relay and connect a fused jumper from terminal A4 (BLK/YEL) wire of the PASS-Key II Decoder Module to ground. Turn Ignition Switch to START.
^ If engine cranks, replace the PASS-Key II Decoder Module.
^ If engine does not crank, check the BLK/YEL (625) wire for an open. If wire is OK, replace the Starter Enable Relay.