Neutral Safety Switch: Adjustments
Neutral Start Switch Removal And Adjustment.:
Rear Of Engine:
IMPORTANT: After switch installation, verify that engine will only start in "Park" or "Neutral". If engine will start on any other position, readjust switch.
ADJUST IF NEEDED
- Place transaxle control shifter assembly in the "Neutral" notch in detent plate.
- Loosen switch attaching screws.
- Rotate switch on shaft assembly to align service adjustment hole with carrier tang hole.
- Insert 2.34 mm (3/32 inch) maximum diameter gauge pin to a depth of 15.0 mm (5/8 inch).
- Tighten attaching screws to 25 Nm (18 ft lbs).
- Remove the gauge pin.