Remove Case Side Cover

Side Cover And Control Valve View:

REMOVE OR DISCONNECT

1. Air cleaner assembly.
2. Negative battery cable.
3. Left torque strut at engine.
4. Left torque strut bracket.
5. One bolt at top of transaxle mount bracket
6. Install J-28467-A and J-36462 Engine support fixtures, or equivalent.
7. T.V. cable.
8. Raise vehicle and support.
9. Left front tire and wheel assembly.
10. Left lower engine splash shield.
11. Left lower ball joint.
12. Pinch bolt at intermediate steering shaft.

CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear or intermediate shaft. Loss of steering control could result.

13. Support right and left sides of frame with jackstands.
14. Right frame to body bolts.
15. Left frame to body bolts, and adjust jackstand to lower left side of frame.
16. Transaxle mount and mount support.
17. Bolts holding engine wiring harness to transaxle case.
18. Transaxle oil cooler lines at transaxle.
19. Transaxle mount bracket.
20. Position drain pan under transaxle.
21. Valve body cover pan and gasket.



CLEAN:

^ Case and side cover gasket surfaces.