Remove Case Side Cover
REMOVE OR DISCONNECT1. Air cleaner assembly.
2. Negative battery cable.
3. Install J-28467-A, J-28467-90 and J-36462 Engine support fixtures, or equivalent.
4. Torque struts at engine mounts.
5. Exhaust crossover pipes.
6. Two bolts at top of transaxle mount bracket.
7. Raise vehicle and support.
8. Left front tire and wheel assembly.
9. Left front brake caliper and bracket.
10. Four bolts at hub and bearing assembly.
11. Left drive axle.
12. Left lower ball joint.
13. Left inner fender splash shield.
14. Pinch bolt at intermediate steering shaft.
CAUTION: Failure to disconnect the intermediate shaft from the rack and pinion stub shaft can result in damage to the steering gear or intermediate shaft. Loss of steering control could result.
15. Support right and left sides of frame with jackstands.
16. Right frame to body bolts.
17. Left frame to body bolts, and adjust jackstand to lower left side of frame.
18. Transaxle mount and mount support.
19. Lower the left side of the engine/transaxle using J-28467-A.
20. Two clamps holding wiring harness to transaxle mount bracket.
21. Transaxle mount bracket.
22. Position drain pan under transaxle.
23. Case side cover pan and gasket.
CLEAN:
^ Case and side cover gasket surfaces.