Replace Case Side Cover

CLEAN:

^ Case and side cover gasket surfaces.


INSTALL OR CONNECT
1. Case side cover pan and gasket.
2. Case side cover bolts and channel plate flange nuts. Torque bolts and nuts to 11 Nm (97 in lb).
3. Transaxle mount bracket.
4. Two wiring harness clamps.
5. Raise left side of engine/transaxle using J-28467-A.
6. Transaxle mount and mount support.
7. Raise left side of frame and install four new frame to body bolts.
8. Remove jack stands.
9. Pinch bolt at intermediate steering shaft.

CAUTION: When installing the intermediate shaft make sure the shaft is seated prior to pinch bolt installation. If the pinch bolt is inserted into the coupling before shaft installation, the two mating surfaces may disengage.

10. Left inner fender splash shield.
11. Left lower ball joint.
12. Left drive axle.
13. Four bolts at hub and bearing assembly.
14. Left front brake caliper and bracket.
15. Left front tire and wheel assembly.
16. Lower vehicle.
17. Two bolts at top of transaxle mount bracket.
18. Exhaust crossover pipes.
19. Torque struts at engine mounts.
20. Remove J-28467-A, J-28467-90 and J-36462 Engine support fixtures, or equivalent.
21. Negative battery cable.
22. Air cleaner assembly.


ADJUST:

^ Fluid level.

INSPECT:

^ For proper completion of repairs.
^ For proper fluid level.
^ For fluid leaks.