Driver/Vehicle Information Display

• Description and Operation
• Testing and Inspection
  • Initial Inspection and Diagnostic Overview
    • System Check
    • Troubleshooting Hints
  • Symptom Related Diagnostic Procedures
  • Component Tests and General Diagnostics
    • Test A: DIC Display Power Test
    • Test B: DIC Module Power Test (STE Only)
    • Test C: Speed Signal Test
    • Test D: Driver Information Center (DIC) Module Test - With Lamp Monitor
      • Tables 1 and 2
      • Table 3
    • Test D: Fuel Signal Test
    • Test E: ECM Signal Test
    • Test F: ABS Ground Short Test (STE Only)
    • Test G: ABS Open Wire Test (STE Only)
    • Test H: Door Ajar Input Test (STE Only)
    • Test I: Trunk Lid Ajar Input Test (STE Only)
    • Test J: Washer Fluid Level Switch Input Test (STE Only)
    • Test K: Hood Ajar Input Test (STE Only)
    • Test L: Compass Calibration and Alignment
    • Test M: English/Metric Test
• Locations
  • Driver Information Center (DIC) Module
  • Driver Information Center/Electronic Compass Display
  • Hud Dimmer Switch
• Diagrams
  • Diagram Information and Instructions
    • Cell References
    • Schematic Symbols
    • Wire Color Code Identification
  • Diagnostic Aids
    • Connector, Splicing and Terminal Repair
      • Pull-to-Seat Connectors
      • Push-to-Seat Connectors
    • General Troubleshooting Procedures
      • Basic Troubleshooting Guide
      • Checking Terminal Contacts
      • Intermittents and Poor Connections
      • Troubleshooting Tests
      • Troubleshooting Tools
    • Handling and Measuring Procedures
    • Wire Repair Procedures
      • Circuit Protection Devices
      • Typical Electrical Repair
      • Splicing Copper Wire Using Crimp and Seal Splice Sleeves
      • Splicing Copper Wire Using Splice Clips
      • Splicing Twisted/Shielded Cable
  • Connector Views
  • Electrical Diagrams
    • Driver Information Center (DIC)
      • Except STE
      • STE
    • Head-Up Display
• Technical Service Bulletins