Engine Side

Heater Inlet Hose/Pipe - Engine Side:

Remove or Disconnect

1. Intake plenum.
2. Recover refrigerant.
3. A/C lines at evaporator.
4. Heater inlet hose at heater core.
5. Inlet pipe retaining nuts.
6. Wiper system electrical connector at cowl.
7. Intake manifold hose at inlet pipe. Service and Repair
8. Heater inlet hose/pipe assembly.

Install or Connect

1. Heater inlet hose/pipe assembly.
2. Engine side inlet hose at inlet pipe.

Important
^ Clamp position (±15 degrees) is at 12 o'clock when viewed from front of vehicle looking towards component nozzle.

3. Wiper system electrical connector at cowl.
4. Inlet pipe retaining nuts.

Tighten
^ Nuts to 3 N.m (27 lb. in.).

5. Heater inlet hose at heater core.

Important
^ Clamp position (±15 degrees) is at 4 o'clock when viewed from front of vehicle looking toward component nozzle.

6. A/C lines at evaporator.
7. Intake plenum.
8. Evacuate, charge and leak test system.