A/C - Reduced Performance/Airflow Restriction

Bulletin Number: 93-1-20
Reference Number: 331218
Publish Date: 7/93

Subject:
REDUCED A/C PERFORMANCE (INSTALL FOAM PANELS/FOAM BLOCK)

Models Affected:
1992-93 BONNEVILLE MODELS

CONDITION

Reduced performance from A/C system. Owner will notice increased performance when the glove box door is open.

CAUSE

Air flow is being restricted by the seals on the glove box door and/or trapped in the glove box door.

CORRECTION

Caution:
When performing service on or around Supplemental Inflatable Restraints (SIR) components or SIR wiring, follow procedures in the service manual, Section 9J, to temporarily disable the SIR system. Refer to the appropriate service manual procedures. Failure to follow procedures could result in possible air bag deployment, personal injury, or unneeded SIR system repairs.

1. Remove glove box insert from instrument panel. Refer to Section





2. Cut out right and left side foam panels using supplied templates (Figure 1). Panels should be cut from 10-12 mm (0.39-0.47 in.) thick foam with adhesive on one side.





3. Remove small pieces 65 x 10 x 12 mm (2.55 x 0.39 x 0.47 in.) of foam (2) from back of duct portion of glove compartment insert. DO NOT remove "C" shaped foam on back of duct (Figure 2).





4. Install foam panels, inside of compartment duct from back side of glove box. The panels are attached to the glove box side of the duct (Figure 3).





5. Remove both glove box door seals from back of glove box door (Figure 4).
6. Cut 3 strips of 10-12 mm (0.39-0.47 in.) thick adhesive backed foam using supplied template (Figure 1). Stick two strips together (adhesive sides together), then stick the third strip on the other two to that no adhesive is showing.

7. Remove right side A/C outlet from glove box door.








8. Insert the foam block into the glove box door above the right side outlet. Make sure that the foam block is retained above the flange that surrounds A/C outlet and does not contact the A/C outlet (Figure 5).
9. Cut lip off both glove box door seals, then reinstall the seals, backwards so the cut area is not visible to the passenger compartment (Figures 4 - 6).
10. Install right A/C outlet to glove box door.

11. Install glove box insert to instrument panel. Refer to section SC.

Labor Operation Number: T3355
Labor Time: 0.8