HVAC Programmer - Revised R&R Procedure
Bulletin Number: 93-10-21Reference Number: 300101
Publish Date: 3/93
SUBJECT:
SERVICE MANUAL UPDATE - SECTION 1C -
REMOVE AND INSTALL PROCEDURE FOR HVAC
PROGRAMMER (DRIVER/PASSENGER SIR) REVISED
Models Affected:
1993 BONNEVILLE MODELS
The following Remove and Install Procedure for the HVAC Programmer 1C-45 has been revised.
PROGRAMMER (DRIVER/PASSENGER SIR)
Figures 6, 7 and 10
Remove or Disconnect
^ Disable SIR System, refer to "Disabling the Supplemental Inflatable Restraint (SIR) System" in this section.
1. Powertrain control module, refer to Section 6E3-C1.
2. Vacuum and lower electrical connectors.
3. Programmer screws.
4. Upper electrical connector and programmer.
Install or Connect
1. Upper electrical connector and programmer.
2. Programmer screws.
Tighten
Screws to 1.4 N-m (12 lb.in.).
3. Vacuum and lower electrical connectors.
4. Powertrain control module, refer to Section 6E3-C1.
^ Enable SIR System, refer to "Enabling the Supplemental Inflatable Restraint (SIR) System" in this section.
Please update your respective service manual accordingly.