Troubleshooting Hints - Power Windows

1. Verify that Circuit Breaker 3 is OK by turning the Ignition Switch to RUN and operating Sunroof (if equipped).
2. Always check terminal contact before replacing any component.
3. If Express Down function does not operate, but window operates, check for battery voltage at terminal A of Express Down Window Module connector and DK BLU (164) wire from terminal C of Express Down Window Module to splice S500 for an open. If both checks are OK, replace Express Down Window Module.
4. If a motor's internal circuit breaker trips, it will not reset until voltage is removed from the motor.
5. If Power Windows do not operate for approximately 10 minutes (or until a door is opened) after Ignition Switch is turned to OFF, see RETAINED ACCESSORY POWER for diagnosis.