Remote Control Door Lock Assembly Receiver

Remote Control Door Lock Receiver Assembly:

Remove or Disconnect

The remote Control door lock receiver assembly (4) is mounted in a pocket on the right-hand hinge pillar.

1. Body hinge pillar trim bolts/screws.
2. Right-hand body hinge pillar trim panel.
3. Receiver assembly (4) from pocket on hinge pillar.
4. Electrical connector secondary lock retainers from electrical connectors.
5. Electrical connectors from receiver assembly (4).

Install or Connect

NOTICE: See "Notice" on page 9K-l~of this section.

1. Electrical connectors to receiver assembly (4).
^ Connector should snap into place.
^ Check for positive connection by tugging on connector, not wire.
2. Electrical connector secondary lock retainers to electrical connectors.
3. Receiver assembly (4) to pocket on hinge pillar.
4. Right-hand body hinge pillar trim panel.
5. Body hinge pillar trim bolts/screws.

Tighten
^ Body hinge pillar trim bolts/screws to 1.3 N.m (12 lb. in.).

6. If programming the system is necessary.