Programming the Receiver

1. Ground receiver program input line by connecting fused jumper wire between terminal "G" on top far right and terminal "A" on bottom far left of DLC (data link connector).
^ Door lock assemblies and lift window lock system will cycle indicating receiver assembly is in program mode.

2. Press any button (only once) on transmitter assembly.
A. Door lock assemblies and lift window lock system will cycle once confirming that transmitter code is programmed.
B. Any transmitter code that was previously programmed has been erased.
C. Receiver assembly is now programmed to transmitter assembly.

3. If programming a receiver assembly to match a second transmitter assembly, press any button (only once) on second transmitter assembly. This must be done before fused jumper wire is disconnected. when programming receiver assembly to match transmitter assemblies, first transmitter code matched will be stored in both receiver memories unless second transmitter assembly is matched at the same time.
^ Door lock assemblies and lift window lock system will cycle once confirming that second transmitter code is programmed.

4. Disconnect fused jumper wire from DLC.
^ System will not operate if ground connection if not removed.

5. Verify operation of each transmitter assembly.