Front Side Door Window

Supporting Front Side Door Window:

Front Side Door Window Rivets (Typical):

Front Side Door Window:

CAUTION: Approved safety glasses and gloves should be worn when performing these procedures to reduce the chance of personal injury should window breakage occur.


REMOVE OR DISCONNECT
1. Lower window about halfway.
2. Front side door trim assembly.
3. Front side door water deflector as needed.

CAUTION: Support front side door window. If window drops into door, personal injury or window damage may result.

4. Support window (1) in position needed to access rivets (19) by inserting rubber wedge door stops front and rear of window (1) between window (1) and door inner panel.
5. Rivets (19).
^ Drill out rivets (19) with l/4-inch drill bit.
6. Window (1) by raising out of door assembly (152)
7. Inspect Bushing assemblies (59), retainers (2), up stop (54), pins (3) and wedges (60) on the window (1) for damage.
8. Bushing assemblies (59) and retainers (2), if necessary, using a flat-bladed tool covered with cloth body tape.
9. Bolt/screw (53), if necessary.
10. Up stop (54), nut (57) and washer (58), if necessary.
11. Bolts/screws (4), if necessary.
12. Pins (3), nuts (61) and wedges (60), if necessary.

INSTALL OR CONNECT
1. Wedges (60) and pins (3), if removed.
2. Tighten bolts/screws (4) to 7 Nm (62 lb. in.) if removed.
3. Tighten nuts (61) to 8 Nm (71 lb. in.). if removed.
^ Nuts (61) stop (54) and washer (58), if removed.
5. Tighten bolt/screw (53) to 7 Nm (62 lb. in.)., if removed.
6. Tighten nut (57) to 8 Nm (71 lb. in.)., if removed.
7. Bushing assemblies (59) and retainers (2), if removed.
8. Window (1) into door assembly (152) so that holes in bushing assemblies (59) line up with holes in channel assembly.
9. Rivets (19) in sequence.

ADJUST
^ Window (1), if necessary.

10. Front side door water deflector.
11. Front side door trim assembly.