Accessory Switch Panel and Switch Opening Cover Assembly

NOTE: If the vehicle is equipped with side window, mirror selector or door lock switches (92, 93, 94 and 114 ), it will have a panel assembly (92). If the vehicle is not equipped with any of these switches, then it will have a cover assembly. Both parts are removed in the same way.

NOTICE: When removing the panel assembly, the ignition switch must be in the "OFF" position and retained accessory power (RAP) must not be present. This will eliminate the possibility of shorting out the switch if a screwdriver, awl or metal object is used.

Accessory Switch Panel Assembly (Typical)-(Pontiac):

Front Side Door Assembly-(Pontiac):

Front Side Door Assembly -Legend:

REMOVE OR DISCONNECT
1. Panel assembly (92) or cover assembly.
^ Pry at front and rear of panel assembly (92) or cover assembly with a flat-bladed tool to release metal clips.
^ Disconnect electrical connectors, if equipped.
^ Remove switches, if equipped and panel assembly is being replaced.

INSTALL OR CONNECT
1. Panel assembly (92) or cover assembly.
^ Install switches if removed.
^ Connect electrical connectors, if equipped.
^ Position panel assembly (92) or cover assembly and press to secure clips.