Inside Handle

COUPE

Door Lock Module:

Remove or Disconnect

1. Door trim panel.
2. Water deflector.
3. Two rivets holding handle assembly, by first center punching a depression in the head of the rivet, then drilling out rivet using a 3/16 inch drill bit.
4. Lock rod at handle.
5. Inside handle by sliding rearward to disengage tabs on handle from slots in module assembly.

Install or Connect

1. Inside handle to module assembly by placing tabs on handle into slots in module and sliding forward.
2. Lock rod to handle.
3. Two rivets using 3/16 inch x 1/4 inch peel type rivets.
4. Water deflector.
5. Door trim panel.