Solenoid Assemblies

Fig. 75 Powermaster III, Exploded View:

Fig. 77 Solenoid Assemblies:

Clean reservoir cover assembly (5) and surrounding area before removing, Fig. 75.
1. Depressurize Powermaster III, refer to DEPRESSURIZING POWERMASTER III.
2. Clean surrounding area, then remove reservoir cover and assembly.
3. Disconnect 3-pin connector (12), from solenoid assembly (14), Fig. 77.
4. Remove solenoid attaching screws (13), then the solenoid assembly. Ensure lower solenoid O-rings are in place and in good condition.
5. Reverse procedure to install, noting the following:
a. Torque solenoid assembly attaching screws to 33-45 ft. lbs.
b. Bleed Powermaster III, refer to DEPRESSURIZING POWERMASTER III.