Throttle Position Sensor: Service and Repair

Throttle Position Sensor:

Typical Throttle Body Assembly:

REMOVAL:

1. Disconnect the Throttle Position Sensor electrical connector.
2. Remove the Throttle Position Sensor mounting screws.
3. Remove the Throttle Position Sensor.

NOTE: The Throttle Position Sensor (TPS) is an electrical component and must not be soaked in any liquid cleaner or solvent, damage may result.

INSTALLATION:

1. With the throttle valve closed, position the Throttle Position Sensor on the throttle shaft, then align the screw holes.
2. Install the Throttle Position Sensor screws and tighten to 2.0 N-m (18 lb. in.).